Numerical modelling of temperature fluctuations of chilled and superchilled cod fillets packaged in expanded polystyrene boxes stored on pallets under dynamic temperature conditionsMARGEIRSSON, Bjorn; PALSSON, Halldór; GOSPAVIC, Radovan et al.Journal of food engineering. 2012, Vol 113, Num 1, pp 87-99, issn 0260-8774, 13 p.Article

Research on the heat transfer model of platen heating surface of 300 MW circulating fluidized bed boilersWU HAIBO; ZHANG MAN; SUN YUNKAI et al.Powder technology. 2012, Vol 226, pp 83-90, issn 0032-5910, 8 p.Article

The performance of absorption―compression hybrid refrigeration driven by waste heat and power from coach engineJIANBO LI; SHIMING XU.Applied thermal engineering. 2013, Vol 61, Num 2, pp 747-755, issn 1359-4311, 9 p.Article

Study on intelligent monitoring methodology based on the mathematical model of heat transfer for blast furnace staveWU LIJUN; LU ZU'AN; SUN GUOPING et al.Applied mathematical modelling. 2010, Vol 34, Num 8, pp 2129-2135, issn 0307-904X, 7 p.Article

Modelling of pyrolysis of large wood particlesANUP KUMAR SADHUKHAN; GUPTA, Parthapratim; RANAJIT KUMAR SAHA et al.Bioresource technology. 2009, Vol 100, Num 12, pp 3134-3139, issn 0960-8524, 6 p.Article

Heat transfer studies on a GAXAC (generator-absorber-exchange absorption compression) coolerRAMESHKUMAR, A; UDAYAKUMAR, M; SARAVANAN, R et al.Applied energy. 2009, Vol 86, Num 10, pp 2056-2064, issn 0306-2619, 9 p.Article

Influences of heat source forms on the cooling capacity of the radiant cooling terminalXIAOLEI NIU; ZHE TIAN; BAODONG DUAN et al.Energy and buildings. 2014, Vol 72, pp 102-111, issn 0378-7788, 10 p.Article

A new Chinese solar kang and its dynamic heat transfer modelMING YANG; XUDONG YANG; PENGSU WANG et al.Energy and buildings. 2013, Vol 62, pp 539-549, issn 0378-7788, 11 p.Article

Research on the actual cooling performance of ceiling radiant panelZHE TIAN; XINGLEI YIN; YAN DING et al.Energy and buildings. 2012, Vol 47, pp 636-642, issn 0378-7788, 7 p.Article

A particle-to-particle heat transfer model for dense gas-solid fluidized bed of binary mixtureJIAN CHANG; SHUQING YANG; KAI ZHANG et al.Chemical engineering research & design. 2011, Vol 89, Num 7, pp 894-903, issn 0263-8762, 10 p.Article

A single particle model for surface-to-bed heat transfer in fluidized bedsDI NATALE, Francesco; LANCIA, Amedeo; NIGRO, Roberto et al.Powder technology. 2008, Vol 187, Num 1, pp 68-78, issn 0032-5910, 11 p.Article

Experimental investigation and model validation of the heat flux profile in a 300 MW CFB boilerRUIQING ZHANG; HAIRUI YANG; NAN HU et al.Powder technology. 2013, Vol 246, pp 31-40, issn 0032-5910, 10 p.Article

Theoretical and experimental analysis of bed-to-wall heat transfer in heat recovery processingRUIQING ZHANG; HAIRUI YANG; JUNFU LU et al.Powder technology. 2013, Vol 249, pp 186-195, issn 0032-5910, 10 p.Article

Influence of different boiling points of pore water around an igneous sill on the thermal evolution of the contact aureoleDAYONG WANG; YONGCHEN SONG.International journal of coal geology. 2012, Vol 104, pp 1-8, issn 0166-5162, 8 p.Conference Paper

Experimental study on condensation heat transfer of steam on vertical titanium plates with different surface energiesQI BAOJIN; ZHANG LI; XU HONG et al.Experimental thermal and fluid science. 2011, Vol 35, Num 1, pp 211-218, issn 0894-1777, 8 p.Article

On-line model-based performance monitoring of a shell-and-tube type heat exchanger using steam and waterWAKUI, Tetsuya; YOKOYAMA, Ryohei.Energy conversion and management. 2008, Vol 49, Num 10, pp 2669-2677, issn 0196-8904, 9 p.Article

Simulation and experimental analysis of optimal buried depth of the vertical U-tube ground heat exchanger for a ground-coupled heat pump systemJINHUA CHEN; LEI XIA; BAIZHAN LI et al.Renewable energy. 2015, Vol 73, pp 46-54, issn 0960-1481, 9 p.Conference Paper

A software independent tool for mapping thermal results to structural modelBANERJEE, Dilip K.Fire safety journal. 2014, Vol 68, pp 1-15, issn 0379-7112, 15 p.Article

Heat transfer model and design method for geothermal heat exchange tubes in diaphragm wallsMENG SUN; CAICHU XIA; GUOZHU ZHANG et al.Energy and buildings. 2013, Vol 61, pp 250-259, issn 0378-7788, 10 p.Article

Swimming pools as heat sinks for air conditioners: Model design and experimental validation for natural thermal behavior of the poolWOOLLEY, Jonathan; HARRINGTON, Curtis; MODERA, Mark et al.Building and environment. 2011, Vol 46, Num 1, pp 187-195, issn 0360-1323, 9 p.Article

A numerical analysis of heat transfer in an evacuated flexible multilayer insulation materialJINJING CHEN; WEIDONG YU.Journal of thermal analysis and calorimetry. 2010, Vol 101, Num 3, pp 1183-1188, issn 1388-6150, 6 p.Article

A hybrid local energy formulation for plates mid-frequency flexural vibrationsHARDY, P; ICHCHOU, M; JEZEQUEL, L et al.European journal of mechanics. A. Solids. 2009, Vol 28, Num 1, pp 121-130, issn 0997-7538, 10 p.Article

Analysis of heat transfer during ohmic processing of a solid foodMARRA, F; ZELL, M; LYNG, J. G et al.Journal of food engineering. 2009, Vol 91, Num 1, pp 56-63, issn 0260-8774, 8 p.Article

Assessing long-term performance of centralized thermal energy storage systemELSAWI, Azeldin; HAGHIGHAT, Fariborz; AKBARI, Hashem et al.Applied thermal engineering. 2014, Vol 62, Num 2, pp 313-321, issn 1359-4311, 9 p.Article

Investigation of deposition in aviation gas turbine fuel nozzles by coupling of experimental data and heat transfer calculationsSIOURIS, Spiridon; BLAKEY, Simon; WILSON, Christopher W et al.Fuel (Guildford). 2013, Vol 106, pp 79-87, issn 0016-2361, 9 p.Article